Turbojet fuel pump - Model 200-C

As an improved version of our older Model 200-B, the Model 200-C is recommended for turbines up to 20 lbs (9.0 kg / 89 N) thrust. Additionally, it is well suited for the smaller turbines such as the Wren Turbine MW44 and MW 54. It works well with the FADEC ECU as well as with the Orbit ECU.

Included and factory installed:

• Stainless steel mounting bracket
  
  
• RF (radio frequency) suppression PCB
  

As with all our pumps, it features extremely high precision stainless steel gears, our unique floating drive gear design and a hard anodized aluminum body. It has a very low current consumption compared to the bigger pumps.

You should use a high quality fuel filter on the inlet side (suction line, before the pump). We recommend you use the Hanger 9 Fuel Filter available in our "Accessories" section.

The pump does not require any break in and is ready to use. It can be installed in any orientation with the included mounting bracket and hardware.

Characteristics:
Weight: 44 g (1.5 oz)
Diameter: 20.0 mm
Length (not including barbed fittings): 44.5 mm
Bypass valve or regulator required: No
RF suppression included: Yes, RF PCB installed
Mounting bracket included: Yes, Stainless steel
High precision stainless steel gears and hard anodized aluminum body
Min. start voltage: 0.70 ± 0.15 Volts
Open flow rate: Approx. 600 ml/min

Click here for complete Model 200-C specs (pdf)

For printing this page, use Landscape page setup